Opera - How to Factory Reset/Clear Pairing History? – Avantree Support

Start Here

Reset Both the Transmitter and Headphones

Reset the transmitter first, then reset the headphones. After both resets are complete, turn them back on to reconnect.

Transmitter

Complete the transmitter reset before moving to the headphones.

Make sure the Opera transmitter is connected to power, then move the PAIR / ON / OFF switch to ON.

OFF ON PAIR

Switch to ON

Slide and hold the PAIR / ON / OFF switch at PAIR for about 8 seconds.

OFF ON PAIR

Hold at PAIR for about 8 seconds

Keep holding the switch at PAIR until the front LED turns solid pink, then release the switch.

Solid Pink = Reset Complete

After the reset, the transmitter automatically re-enters pairing mode. The front LED will flash red and blue.

Flashing Red / Blue = Pairing Mode

Transmitter reset complete. You can now reset the headphones.

Headphones

After resetting the transmitter, clear the headphones' pairing history.

Make sure the Opera headphones are powered ON.

Press and hold the volume + and − buttons together for about 6 seconds.

+ Hold Together
About 6 Seconds −

Keep holding until the red and blue LEDs turn on together for about 2 seconds. Together, they may appear pink.

Pink for About 2 Seconds = Reset

After the reset, the headphones automatically enter pairing mode. The LED will flash red and blue.

Flashing Red / Blue = Pairing Mode

Headphone reset complete. Both devices are now ready to reconnect.

Use the Opera Buttons & Indicators guide to identify the controls and LED indicators on the transmitter and headphones.

Turn the Opera transmitter ON.

Turn the Opera headphones ON.

Keep the headphones close to the transmitter and allow them a few seconds to reconnect.

Tell us what LED pattern you see on both the Opera transmitter and headphones after completing the reset.