How to Factory Reset/Clear Pairing History of Oasis Plus – Avantree Support

Oasis Plus: Factory Reset / Clear Pairing History

Having trouble connecting your Bluetooth headphones or speakers? Clearing Oasis Plus's pairing history can help you start a fresh Bluetooth connection.

Follow these 3 simple steps. Select Next to continue.

Important: TX and RX Have Separate Pairing Histories

Oasis Plus has two independent Bluetooth modes: TX (Transmitter) and RX (Receiver). Make sure you select the mode you want to reset. Resetting one mode does not clear the pairing history of the other mode.

1 Select Mode

2 Hold + and −

3 Confirm Reset

STEP 1 OF 3

Power On Oasis Plus and Select the Mode

Move the power switch to either TX or RX, depending on which pairing history you want to clear.

TX — Transmitter Mode

Select TX if you use Oasis Plus to send TV audio to Bluetooth headphones or speakers.

RX — Receiver Mode

Select RX if you use Oasis Plus to receive Bluetooth audio from a phone or other device.

Example: Resetting TX Mode

TX RX

For Bluetooth headphones connected to your TV through Oasis Plus, select TX.

Remember: If you want to clear both TX and RX pairing histories, repeat the reset procedure separately in each mode.

Step 1 of 3 Next →

STEP 2 OF 3

Press and Hold the + and − Buttons Together

Locate the + and − buttons on Oasis Plus.

Press Both Buttons at the Same Time

+ & −

HOLD FOR 7 SECONDS

Keep both buttons pressed simultaneously.

Do Not Release Too Early. Continue holding both buttons until you hear the voice prompt "Pairing history cleared."

SUCCESSFUL RESET VOICE PROMPT "Pairing history cleared"

This confirms the pairing history has been cleared successfully.

Important: The reset is confirmed by the voice prompt, not simply by counting seven seconds.

← Back Step 2 of 3 Next →

STEP 3 OF 3

Confirm the Reset and Pair Again

Once the pairing history is cleared, Oasis Plus automatically enters Bluetooth pairing mode.

TX Mode: Pairing Indicator

Flashing Green / White indicates that Oasis Plus is ready to pair with a Bluetooth device.

Reset Complete!

Oasis Plus's pairing history has been cleared for the selected mode.

Next Step: Put your Bluetooth headphones or speakers into pairing mode and reconnect them to Oasis Plus.

← Back Step 3 of 3 Start Over

Common Questions

Will Resetting TX Also Reset RX?

No. TX and RX have separate pairing histories. Resetting TX does not clear RX, and resetting RX does not clear TX.

To clear both, perform the reset separately in each mode.

I Held + and − but Did Not Hear the Voice Prompt

Make sure Oasis Plus is powered on and switched to TX or RX.

Press and hold both buttons together for approximately seven seconds. Do not release them until you hear "Pairing history cleared."

If the voice prompt is not heard, try the procedure again.

My Headphones Still Reconnect to Another Device

Bluetooth headphones often reconnect automatically to the last device they were paired with.

Temporarily turn off Bluetooth on your phone, computer, or other previously connected device.

Then put the headphones into pairing mode and reconnect them to Oasis Plus.

Should I Reset My Bluetooth Headphones Too?

If pairing problems continue, clearing the pairing history on both Bluetooth devices can help.

Follow your headphone manufacturer's instructions to clear its pairing history.

For phones or computers, try switching Bluetooth off and back on before reconnecting.

Does Factory Reset Change My TV Audio Settings?

This procedure clears the Bluetooth pairing history for the selected Oasis Plus mode.

It does not change your TV's audio output settings.

Still Need Help?

Tell us whether you are using TX or RX mode, whether you heard the "Pairing history cleared" prompt, and the brand and model of your Bluetooth headphones or speakers.

ASK A QUESTION