Audition Pro / AS9P - Troubleshooting - Charging Issue / Can't Hold Charge

Follow

Keywords: Audition Pro, can't hold charge, hold, battery, recharge, power, charging issue

THANKS for choosing Avantree Products! Please DO NOT worry when any problems encountered during you use them because the device comes with 24 months warranty!  

 

There are THREE possibilities if the headset seems no longer hold a charge  

  1. The battery didn't fully recharged
  2. The battery life depends on the audio source type/ audio volume 
  3. The battery of the headset is a defective unit  

======

  1. Headphones is not properly well recharged?

When the LED blinks red, you should recharge your headphones. Please remove the micro-USB protector and charge the headphones via the supplied USB to AC adapter or PC USB port. It normally takes about 3 hours to fully charge the battery. The LED will stay red when charging and will turn off when charging is complete.

Charging requirement: You can plug our supplied USB cable to your own USB chargers(wall charger/travel charger/car charger,etc) with 5V/500mA-2A or PC USB port. It is OK to use most mobile phone chargers on the market.

If no LED lights at all when you try to charge, and when you press and hold the MFB for 5s and no LED light at all, then the headphone might be defective. Please contact support@avantree.com for RMA support.

We also suggest you to try with another USB cable because there is a higher chance the USB cord is broken than the headphone itself. 

======

     2. The battery life depends on the audio source type/ audio volume

The battery life depends on how loud you listen to music. Listening at full volume will cause the battery to deplete faster compared to listening at half or 1/4 volume. Generally though, the battery life in wireless mode is around 40 hours of playback on 60% music volume. Since the Audition has WIRED Mode, so you can use the included 3.5mm AUX audio cable to stream music as a "WIRED Mode" once the internal battery is drained.

 

======

     3.The battery of the headset is a defective unit

If the charging cable works FINE and the headphones were charging for a good amount of time (no less than 3hrs) But the headphones still can't hold a reasonable enough time OR  they always randomly shut off in Bluetooth mode despite a full charge, if these two cases occurred, it seems that the headset maybe a defective unit. Please contact support@avantree.com for a replacement directly! 

 

If any of the above solutions is helpless please contact  support@avantree.com for help! 

 

Have more questions? Submit a request

Comments