Oasis - Guide - Status LED indicator

Oasis LED indicator as below -

Status  LED indicator  Voice Prompt Image 
TX - Pairing "TX" LED flashes GREEN and WHITE alternately Pairing mode - Please put your device into pairing mode and wait. TX---Pairing.gif
RX - Pairing "RX" LED flashes GREEN and WHITE alternately Pairing mode - Please put your device into pairing mode and wait. RX---Pairing.gif
Single connected LED A will light up. Connected. Ready for use. Single_connected.jpg
Dual link Connected LED A and B will light up. Connected. Ready for use. Dual_link_Connected.jpg
TX reconnected "TX" LED flashes WHITE Reconnecting to the last paired device. TX-reconnected.gif
RX reconnected "RX" LED flashes WHITE Reconnecting to the last paired device. RX-reconnected.gif
Bypass(directly cable connection) LED" "is on Power on. Bypass mode.  Please ensure  the correct input/output mode is set. Bypass.jpg
Connected with device using SBC (or APTX or aptX low latency) codec SBC(or APTX or LL) will be on / SBC.jpg

Optical cable is plugged in and switch

"  " to OPT

"OPT" LED is on Optical mode. Please ensure optical cable is connected. OPT.jpg

Aux cable is plugged in and switch

" " to AUX

 

"AUX" LED is on Auxiliary mode. Please ensure auxiliary cable is connected. AUX-1.jpg
Pairing with unknown device. Turn off your wanted pairing device. LED A is still on / Single_connected.jpg

 

Bluetooth Audio Delay Experiment - aptX Low Latency vs others

https://www.youtube.com/watch?v=4_bypcPW5O4&feature=youtu.be

Have more questions? Submit a request

Comments